Description

This kit is used to raise the height on the front of the vehicle without maxing out the Torsion bars and creating a harsh ride on the bump stops.

They also allow for greater articulation on the front end.

Doing an upper ball joint flip and fitting spacers gives you more clearance between the upper control arm and the bump stops, which will allow you to turn the torsion bar up more which will give you more lift!

The kit includes the following:

2 x 10mm Ball Joint Spacers

6 x HT Bolts

6 x Nylock Nuts

6 x Spring Washers

1 x Instruction Manual

TAKE NOTE

YOU NEED TO DO WHEEL ALIGNMENT & SHIMMING after installation

INSTRUCTIONS
1.      Park the Vehicle on a level concrete surface with the steering wheel centered.
2.     Block/chock rear wheels to prevent the vehicle movement.
3.     Jack the front end up and secure the vehicle on jack stands.
4.     Remove front wheels.
5.     Remove the Ball Joint – its is mounted on-top of the control arm.
6.     Insert the Ball Joint Spacer following by the Ball Joint,
Using a floor jack to control arm height, align the Ball Joint and install.
(See below picture for reference)
7.    Tighten Ball Joint bolts to 40 N.m
8.    Put wheels back.
9.    Check bump stop gaps and turn tortion bars up or down – Bump Stop gap needs to be 9-12mm
10.  YOU NEED TO DO WHEEL ALIGNMENT & SHIMMING